If your data collector is connected to the Internet and your GPS Base is broadcasting on a Static IP address you can use the steps below:
- Run Equip / GPS Rover and tap the RTK tab
- Change it to the settings shown below:
- Device: Data Collector Internet
- Network: TCP/IP Direct
- RTK Port: Data
- Then tap the "wrenches" icon in the bottom right corner
- In the Configure TCP/IP Direct screen tap the pull-down list next to "Name:" and tap on <NEW> then type a nickname for your base such as "Base1" without quotes
- Type in your IP address, Port. The IP address and Port number should be provided to you by your TCP/IP Direct Provider. It is not something which we provide to you.
- Set the RTK Message type. DO NOT check the Send Rover position box. Then, tap the Green Check.
- Now you can tap the Green Check to configure your Rover and check in Equip / Monitor Skyplot to see if you’re getting corrections from your Static IP address GPS base.